ARE 5.0 Project Planning & Design Exam Prep

Previous Chapter:
Objective 2.3. Integrate multiple codes to a project design

Currently Viewing:
Objective 3.1: Determine Mechanical, Electrical, and Plumbing Systems

Course Videos
Practical Applications - Upgrade to Pro

Up Next:
Objective 3.2: Determine Structural Systems

You have reached one of our paid video tutorials for the course:

ARE 5.0 Project Planning & Design Exam Prep

You can either log in to view it or learn more about our memberships.

OLED Lighting Systems

5m 12s

In this ARE 5.0 NCARB-approved Project Planning and Design Exam Prep course you will learn about the topics covered in the ARE 5.0 PPD exam division. A complete and comprehensive curriculum, this course will touch on each of the NCARB objectives for the ARE 5.0 Project Planning and Design Exam.

Instructor Mike Newman will discuss issues related to the generation or evaluation of design alternatives that synthesize environmental, cultural, behavioral, technical and economic issues.

When you are done with this course, you will have a thorough understanding of the content covered in the ARE 5.0 Project Planning and Design Exam including design concepts, sustainability/environmental design, universal design, and other forms of governing codes and regulations. 

Transcript summarylog in to access this content in full.

This is the organic LEDs, and this is a setup that's very similar in concept to regular LED if you remember regular LED has the little diode system, got a little solid state element and it's got electrical connection on one end and an electrical connection on the other, and so the power sort of goes through it when the diode gets the power going through, that's what it's giving off the light, but for the OLEDs, instead of it being in this very simple straightforward almost like a wire connection and then this little moment in between that has the diode in it, it's done in these layers so I might have a layer of essentially the same as the diode and I would have potentially a layer underneath it that is the one side of this sort of electrical connection, it's like a gel that the electrical can move through, and then I would have another layer on the other side that electrical connection can move through. So I have three layers and one of them is the diode, the other two are about allowing this electrical process to happen, and then they get smashed together and so they're very thin, they're so thin that they can be rolled up. So you can have flexible materials that actually produce light.

Log in to access files

From the course:
ARE 5.0 Project Planning & Design Exam Prep

Duration: 30h 57m

Author: Mike Newman